Project is to verify the EMF meters as per standard

This is portable handheld that allows easy verification and maintenance of field devices including transmitter and sensors of process industry. This device will simulate as well verifies the field device sensor as per the parameters to be verified and sends the measured value to PC application using USB communication for generation of device failure or passing certificates.

DHH 805 is universal portable configuration tool that allows easy parameterization of ABB and third party HART® instruments. Every HART® field device may be configured, polled, and trimmed using the DHH805. Worked on HART secondary master protocol changes as well as HART DD reading routines stored in SD card for some methods.

This is a microcontroller-based tag detection, monitoring and deactivation system for commercial shops. This system uses freescale ARM Cortex based controller over MQX RTOS platform. System has controller and SPI based RFID chip to handle the tag detection with four antenna feasibility.

Minerva is the microprocessor-based railway braking system. This system uses free scale cold fire based for ECU with MQX RTOS platform to handle the braking system. System has one master ECU for the train with slaves ECU for the each car. This has brake n/w and train n/w over Ethernet to control the brake as well as send /receive command to/from train management control software.

To control the light using DALI protocol

This product is designed for automated controlling the lights in homes, apartments, Industrial and commercial places for saving energy. This is retrofit product, which communicates with existing lighting ballast using DALI protocol and proprietary ECO protocol.

CL7 Regulator is single phase step voltage regulator which has motor driven Tap changing autotransformer. It provides constant monitoring of the transformer voltage and generates a RAISE or LOWER control signal to the motor drive of the tap changer when the measured voltage differs from pre-set values. It include built-in metering, voltage limiting, voltage reduction, reverse power flow detection and operation, time-tagged demand metering, profile recorder, tap position tracking, and source voltage calculation without an additional potential transformer.

Fire control panel in which both System Sensor Inc (Now part of Honeywell Inc.) and Apollo devices supported with FLASHSCAN and APOLLO protocol to control the operations of the fire detectors (Photo, Heat, ION etc).

The Wireless Gateway is the product developed to integrate the wireless devices with existing wired fire control system panels. Gateway exchanges the messages between wired devices protocol and wireless protocol.

System Sensors CLIP/Flashcan protocol based fire detector/module simulator for various fire panels including Honeywell, Notifier, Firelite and Silent Knight Panels. This simulator has two controller where one is to handle the communication setting from PC and other to simulate the command over loop driver using PWM.

Device which is used to measure the hazardous gas and transmts to control system over HART and Modbus

XNX is an extremely flexible transmitter that can be configured to accept an input from any of the Honeywell Analytics range of gas sensor technologies. It can also be configured to provide a wide variety of industry standard output signals. This enables users to have a single type of interface to all their gas detection needs, even when different types of detectors are employed, to most effectively address the different gas detection applications on site.

This is an instrument designed by our company to test the triggering time of over current relay and serial LCD to display error and VB front end to show error on PC.

This is an instrument designed by our company to calibrate electronic Energy meter as per the electricity board standard for manufacturing unit. Supports 32 device calibration at a time over RS485 communication.

CL7 Regulator is single phase step voltage regulator which has motor drivenTap changing autotransformer. It provides constant monitoring of the transformer voltage and generates a RAISE or LOWER control signal to the motor drive of the tap changer when the measured voltage differs from pre-set values. It include built-in metering, voltage limiting, voltage reduction, reverse power flow detection and operation, time-tagged demand metering, profile recorder, tap position tracking, and source voltage calculation without an additional potential transformer.